CD60 2WIRE ROUND CAPACITOR/RUNNING 200UF 250V (VEH2175 )

Engineered specifically to handle the high electrical demands of industrial machinery, this premium 200 microfarad (uF / MFD) capacitor provides the critical phase-shifting power required to overcome heavy static loads. Whether you are replacing a failed, bulging, or weak factory capacitor, this unit delivers a reliable, high-torque boost to ensure your machinery spins up smoothly and rapidly every time you flip the switch.

Key Performance Features

High-Torque Phase Splitting: Engineered specifically to jump-start single-phase induction motors by creating the optimal phase angle shift, reducing startup lag and preventing motor humming or overheating.
Vibration-Resistant Shell: Encased in a rugged, moisture-proof, non-conductive phenolic resin outer cylinder designed to withstand severe industrial environments, high-vibration tool setups, and sudden physical impacts.
Pre-Wired 2-Wire Configuration: Comes factory-equipped with two heavy-duty insulated wire leads (pig-tails). Because it is a non-polar AC capacitor, there is no positive or negative terminal, making wiring straightforward and hassle-free inside tight motor junction boxes.
Self-Healing Dielectric Material: Built with premium-grade metalized film layers that feature self-healing properties. In the event of a minor voltage spike, the dielectric layers isolate the fault, preventing catastrophic short circuits and significantly extending the service life of the part.
Broad Voltage Versatility: Conservatively rated at 250V AC. This heavy-duty rating means it can safely and reliably replace older or lower-rated 110V, 125V, 165V, or 220V AC start capacitors of the same microfarad capacity.

Technical Specifications
Capacitance: 200 uF (Microfarads) / MFD
Rated Voltage: 250V AC
Frequency Compatibility: Dual-rated for 50Hz and 60Hz systems
Capacitance Tolerance: ±10% (Industrial Standard)
Operating Temperature Range: -40°C to +65°C / -40°F to 149°F
Terminal Type: 2-wire insulated flexible copper leads

Universal Equipment Compatibility
This CD60 200uF capacitor is a universal drop-in replacement across a massive range of heavy-duty shop equipment, agricultural machinery, and commercial appliances, including:
Air Compressors: Perfect for 2HP to 5HP single-phase compressor motors that struggle to start under pressure.
Floor Maintenance Gear: Fits heavy-duty walk-behind floor buffers, concrete sanders, and restoration equipment.
Water Pumps: Compatible with deep-well submersible pumps, centrifugal irrigation pumps, and pool motors.
Workshop Machinery: Fits wood lathes, table saws, dust collectors, and metal drill presses.

Installation & Safety Guidelines

1. Safety First: Disconnect the machinery from all electrical power sources before opening the motor terminal box.
2. Discharge the Old Unit: Capacitors store dangerous electrical energy even when disconnected. Always use an insulated screwdriver to short across the terminals of the old capacitor to safely discharge it before handling.
3. Direct Swap: Disconnect the old wiring and attach the two new insulated leads to the matching motor terminals. Secure the capacitor tightly inside the housing bracket to minimize vibration wear.